Automotive training equipment electrically controlled dual-fuel engine trainer

GTAT-1003

Delivery:

EXW

minimum order:

1 set

Supply Ability:

30set / Month

Country of Origin:

Guangzhou,China

Stock Time:

45Day

Technical parameter
1. Dimension: 1100x1500x1810mm; (L x W x H)
2. Battery: 12V/60AH
3. Fuel tank capacity: 10L/gasoline, 2m3/gas
4. Coolant: Glycol

Quantity:

Request a Quote

The automotive training equipment engine trainer engine teaching model displays the basic principles and structures of electrically controlled dual-fuel engine, and simulates its operation. This electrically controlled dual-fuel engine trainer automotive training equipment can be used to learn the basic knowledge, inspection work and other knowledge and skills of electrically controlled gasoline engine. The automotive training equipment engine teaching model is also suitable for the teaching and skills training of electrically controlled dual-fuel engine in higher vocational colleges and secondary vocational colleges. At the same time, automotive training equipment engine trainer can also be used as an dual-fuel engine teaching model for skill training and skill appraisal in technical schools, vocational education centers, and vocational qualification appraisal stations.

Technical parameter

1. Dimension: 1100x1500x1810mm; (L x W x H)

2. Battery: 12V/60AH

3. Fuel tank capacity: 10L/gasoline, 2m3/gas

4. Coolant: Glycol

Product description

The trainer displays the basic principles and structures of electronically controlled duel fuel engine, and simulates its operation.

Product composition

Dual fuel engine assembly	1PCS
ECU	1PCS
Dashboard	1PCS
Fault setting module (Manual switch type)	1PCS
Battery	1PCS
Mobile stand with test panel	1PCS
OBD diagnostics seat	1PCS
Pressure gauge	2PCS
Sensor signal meter	3PCS
Gas tank	1SET

Main Features

Can simulate engine running, starting, acceleration, deceleration, idling, fault detection and diagnosis, fault simulation, etc.
Equipped with fault setting module can simulate multiple failures in the real engine.
Equipped with voltmeter to show the real-time change of the sensors and actuators
Equipped with LED light to simulate the status of the injecting system.
Equipped with diagnosis seat which can use a scanner to read the fault codes and data stream of the engine control system through the diagnosis seat.
The training panel is printed with the color circuit schematics which makes the students can understand and analyzing the engine control system directly.
There are test terminals mounted on the training panel, electrical signal, such as the resistance, voltage, current, frequency, waveform of the sensors, actuators can be measured by multimeter or oscilloscope through the test terminals.
Equipped with ignition switches, relays, safety devices, safety shields, flywheels and other rotating parts shields.
Equipped with fault setting module: Manual switch type (Optional intelligent type)

Training courses

1. Introduction of main components;

2. Demonstration of engine operation, startup, acceleration, etc.;

3. Sensor and actuator signal measurement;

4. Operation of the scanner;

5. Fault set and troubleshooting;

6. Engine basic maintenance;

Suitable engine models listed below:

P.N.	Engine model
GTAT-1003-001	Jetta 1.6L
GTAT-1003-002	Santana AJR
GTAT-1003-003	Toyota Vios 1ZR-FE

Recommend Products

Send Message