GT2025121610
Technical Specifications:
Automotive Starting, Charging & Ignition Panel Trainer
 
Features:
● This automotive training equipment should fully display the composition and structure of automotive start, charging, and ignition system.
● The test terminals should be installed on the test board and should measure electrical signals such as resistance, voltage, current, frequency, etc. of circuit components in the system.
● Fault setting module: manual switch type
 
Technical Specifications:
● Dimension: Min. L134xW65xH180cm
● Power supply: AC220V, 50Hz
 
Training Programs to be performed:
● Function introduction of the main components of the car starting, charging, and ignition system;
● Demonstration of the working process of the car starting, charging, and ignition system;
● Use of scanner;
● Signal measurement of sensors and actuators;
● Fault setting and troubleshooting.
 
Trainer must have followings: 
● Ignition system - 1PCS
● Starting system - 1PCS
● Charging system - 1PCS
● Drive motor (AC220V, Min. 0.75KW) - 1PCS
● Battery (Min. 12V/45AH) - 1PCS
● Ignition switch - 1PCS
● Fuel tank - 1PCS
● Fault set module (Manual switch type) - 1PCS
● Mobile stand with test panel - 1PCS

Send Message

  • You can only upload 1 attachments at most
  • Supported formats: PDF,JPG,PNG,EXCEL,WORD,STP,IGS,DWG,DXF,PDF,STEP
  • The size of the uploaded file should not exceed 10MB
Service

Inquiry
Email
Phone
Wechat