Order No.: GT2024072801
 
Specification
The system must be modular and scalable to allow the addition of possible complements:
- Square passage section of 250 mm side
- Axial fan with a diameter of 250 mm with speed variator
- Variable air flow from 0 to 14 m³/ s
- Humidification by steam injection provided by a steam generator
- Steam generator: stainless steel tank with porthole and drain
- Equipped with automatic and electric water level control and three electric heaters (two 2kW). and one of 1kW)
- Preheating with two 1kW electrical elements equipped with fins
- Direct expansion cooling with finned exchanger
- Nominal cooling capacity of 2kW
- Refrigeration unit operating on R134A and equipped with a thermostatic valve. hermetic 3/4 HP with air-cooled condenser speed 2700 to 3000 rpm and swept volume 25.95 cm³/cycle, 2.2kW at +5°C
- Heating two 1kW electrical elements equipped with fins
- Four pairs of thermometers for measuring dry and wet temperatures in the air treatment pipe and three thermometers for the refrigeration unit
- Three Bourdon-type manometers for measuring the pressure at the evaporator outlet, at the inlet and at the condenser outlet
- A flow meter for the refrigerant - Diaphragm and inclined pressure gauge for measuring the air flow
- Analog voltmeter
- Electrical safety devices for the entire installation, the electrical resistances of the heaters and the generator steam, compressor and fan and pressure switch to the compressor.
- A laminated psychometric diagram of the air and an enthalpy diagram of the refrigerant laminated in A2"format

Send Message

  • You can only upload 1 attachments at most
  • Supported formats: PDF,JPG,PNG,EXCEL,WORD,STP,IGS,DWG,DXF,PDF,STEP
  • The size of the uploaded file should not exceed 10MB
Service

Inquiry
Email
Phone
Wechat