Order No.: GT2023061201
Specification:
INTRODUCTION
Energy saving and environmental pollution reduction are crucial global issues. Using renewable energies as alternative sources to fossil fuels can address both issues, with great benefits especially in countries where traditional energy sources are scarce.
Considering the above, this system enables experimental investigation on the conversion of solar energy into electricity exploiting the photovoltaic effect and of wind energy into electricity by means of a wind power generator. The equipment is manufactured using real components available on the market.
 
DESCRIPTION 
System configuration:
• Stand-alone (isolated from the grid) or
• Grid-connected
 
The system consists of:
A) Silicon cell photovoltaic panel
A.1) Solar radiation sensor
A.2) PV panel temperature sensor
B) Horizontal axis wind power generator
B.1) Wind speed sensor
C) Table top control panel for OFF-GRID operation including:
C.1) Charge regulator
C.2) DC electric load (lamp)
C.3) Electric instrumentation for detecting the energy flows in the circuit branches
C.4) PC data acquisition system
D) Buffer battery
E) Table top control panel for ON-GRID operation including:
E.1) Grid-Tie Inverter
E.2) AC electric load
E.3) Electric instrumentation for detecting the energy flows in the circuit branches
E.4) PC data acquisition system
 
TRAINING PROGRAM
• Components of a combined no-grid / off-grid wind and solar system for electricity production
• Effect of solar radiation on the panel output voltage (*)
• Effects of shading on a real solar installation (*)
• Photovoltaic panel energy conversion efficiency (*)
• Effect of the wind speed on the generator output voltage (**)
• Wind generator energy conversion efficiency (**)
• Battery charging system management
• Interconnection of solar/wind power energy to the public grid
• Operation and efficiency of a DC/AC inverter
• Connection to portable rheostat PRH-1 (optional item - refer to the end of this data sheet) for photovoltaic panel characteristic curve construction
• Connection to wind power generator indoor operation device WG-IE (required - refer to the end of this data sheet) for wind generator characteristic curve construction

Send Message

  • You can only upload 1 attachments at most
  • Supported formats: PDF,JPG,PNG,EXCEL,WORD,STP,IGS,DWG,DXF,PDF,STEP
  • The size of the uploaded file should not exceed 10MB
Service

Inquiry
Email
Phone
Wechat