PI GT2025070701
Technical parameters:
The training program allows at least the following options:
- Analysis of injection timing control depending on:
- Number of revolutions;
- Engine temperature;
- Engine load;
- Analysis of ignition angle control;
- Checking the operation of the non-evaporation valve depending on engine load conditions;
- Analysis of the waveform of the signal that allows the throttle to be actuated;
- Analysis of the waveform of the signals coming from the crankshaft position sensor and the camshaft sensor;
- Troubleshooting.
 
Equipment equipped with at least the following circuits and devices:
-Fuel supply circuit
- Transparent plexiglass tank
- Engine-driven pump with its own relay
- Fuel filter
- 4 electronic injectors with transparent plexiglass manifold
- Fuel vapor recirculation solenoid valve
- Lambda sensor
- Intake air pressure sensor with its own simulator
- Engine temperature sensor with its own simulator
- Accelerator pedal potentiometer
 
Engine-driven throttle valve control circuit
- 4 spark plugs
- Induction coil
- High voltage protection and access to electrical-electronic equipment connectors
- Ignition key with locking system
- Electronic control unit for system management
- Command and control module for connection and diagnostics via OBD
- Dashboard updated via multiplex
- Simulator of the safety pressure switch of AC equipment with R134A
- Polar wheel with magnetic sensor
- Camshaft polar wheel with hall sensor
- Electric motor with electronic control for engine rotation simulation
- Potentiometer for vehicle speed regulation
- Dashboard fully connected with the main module
 
The stand mounted on wheels will include the following elements:
- Key start/stop
- Key drawer
- 12 V DC battery and battery charger
- Power supply: 230 Vac 50 Hz single phase

Send Message

  • You can only upload 1 attachments at most
  • Supported formats: PDF,JPG,PNG,EXCEL,WORD,STP,IGS,DWG,DXF,PDF,STEP
  • The size of the uploaded file should not exceed 10MB
Service

Inquiry
Email
Phone
Wechat