This electric vehicle training equipment battery management system trainer is suitable for the management and maintenance training of new energy vehicle batteries in vocational and technical schools, colleges and universities, and training institutions. The battery management system trainer electric vehicle training equipment is an useful automobile teaching equipment for vocational training schools.This automobile teaching equipment battery management system trainer is based on the original electric vehicle battery management system components. The automobile teaching equipment electric vehicle training equipment is suitable for the teaching needs of the theory and maintenance training of electric vehicle battery management system in vocational and technical schools, colleges and universities, training institutions.
 
Technical parameter:
Dimension: 1380x600x1800mm (LxWXH)
Power supply: single-phase, AC220V/50Hz;
 
Product description:
This training board displays and simulates the working process of the power battery pack and management system, and can conduct charging and discharging experiments on the battery pack, as well as various battery parameter tests. 
 
Product composition:
1. Battery pack: 20pcs lithium iron phosphate batteries 3.2V/20AH;
2. Battery protector;
3. Emergency switch;
4. Intelligent charging device: output 73V/5A, automatic charging recognition;
5. Two sets of battery temperature sensors: for monitoring battery temperature;
6. BMS management module;
7. BMS information display;
8. Motor drive controller;
9. DC brushless motor: DC60V/500W, speed 0~3000rpm;
10. Accelerator pedal assembly;
11. Ignition switch;
12. Charging switch;
13. Cabinet;
14. Oscilloscope;
15. Leakage protection switch;
16. Test cabels;
 
Training Courses:
Training course 1: Brief introduction of main components
Training course 2: Functional demonstration
Training course 3: Fault setting and troubleshooting
Training course 4: Signal testing experiment
Experiment 1: Battery internal resistance measurement
Experiment 2: Battery capacity measurement
Experiment 3: The basic discharge curve drawing of the battery
Experiment 4: Analysis of different power discharge curves
Experiment 5: Battert dicharge experiment(free combination circuit)
Experiment 6: Constant voltage discharge
Experiment 7: BMS managerment system setting
Experiment 8: Motor voltage measurement
Experiment 9: Motor speed measurement
Experiment 10: High-voltage motor drive controller setting
Experiment 11: High-voltage motor operation wave measurement
Experiment 12: Electrical appliance power discharge curve analysis
Experiment 13: Dynamic and static measurement of accelerator pedal
Experiment 14: The use of oscilloscope
Experiment 15: Wire connection measurement application
Experiment 16: Battery constant voltage and current charging
Experiment 17: Constant voltage charging
Experiment 18: Constant current charging
Experiment 19: Constant voltage and constant current charging(quick charge)

Send Message

  • You can only upload 1 attachments at most
  • Supported formats: PDF,JPG,PNG,EXCEL,WORD,STP,IGS,DWG,DXF,PDF,STEP
  • The size of the uploaded file should not exceed 10MB
Service

Inquiry
Email
Phone
Wechat