Diesel engine electronic control system training board

GTAT-4003A

Delivery:

EXW

minimum order:

1 set

Supply Ability:

30set / Month

Country of Origin:

Guangzhou,China

Stock Time:

45Day

Technical parameter
1. Dimensions: 1340x650x1800mm
2. Power supply: AC220V, 50Hz

Quantity:

Contact Now

The diesel engine control teaching equipment automotive training board is designed to demonstrate the structure and working process of engine control system.The engine control teaching equipment automotive training board is also suitable for the teaching and skills training of related majors in higher vocational colleges and secondary vocational colleges.

Technical parameter

1. Dimensions: 1340x650x1800mm

2. Power supply: AC220V, 50Hz

Product description

This training board adopts the electronic fuel injection system components of the original common rail diesel engine, fully demonstrating the composition structure and working process of the electronic fuel injection system of the common rail diesel engine. Suitable for teaching the theoretical and maintenance training needs of the fuel injection system for common rail diesel engines.

Product composition

Mobile stand with test panel	1SET
Engine ECU	1SET
Ignition switch	1PCS
Diagnostic seat	1PCS
Fuel tank，10L	1PCS
Oil pump with pump plug	1SET
Oil pump reply	1PCS
High pressure oil pump assembly	1PCS
Electronic accelerator	1PCS
Flowmeter	1SET
Oil rail with 4 glass measuring cups	1SET
Fuel injection nozzle	4PCS
Crankshaft position sensor and signal wheel	1SET
Glow plug	4PCS
Glow plug relay	1PCS
Hand oil pump	1PCS
Speed regulating motor and speed regulator	1SET
Fault set module（Manual switch type）	1SET

Main features

1. The automotive training board can measure the voltage, resistance, frequency and other electrical signals of sensors and actuators in the electronic control system.

2. Equipped with an OBG diagnostic seat, it can read and clear fault codes of the electronic control system, read data streams and other operations.

3. The test panel is equipped with measurement terminals that can measure signals related to sensors and actuators.

4. Equipped with fault setting module: manual switch type (optional intelligent type).

Training courses

1. Introduction of main components;

2.Operation and use of the training board;

3. Demonstration of the work principle of engine control system;

4. Detection of the signals of the sensors and actuators by multimeter or oscilloscope;

5. Fault setting and troubleshooting;

6. Use of scanner.

Suitable car or engine models listed below:

P.N.	Car model
GTAT-4003A-001	Isuzu 4JB1 high pressure common rail
GTAT-4003A-002	Great wall 4D20 high pressure common rail

Recommend Products

Send Message