The ignition control simulator automotive training equipment driving school lab equipment describes the working principle of the anti-theft, ignition simulator, the fault setting and troubleshooting. By using this automotive training equipment, students can deeply understand and master the components, working principle, fault diagnosis and troubleshooting of the anti-theft ignition simulator.
 
Technical parameter
1.Dimension: 1340*650*1800mm(LxWxH)
2.Power supply: AC220V, 50Hz
 
Product description
The training board of the original car anti-theft ignition system, the automotive training equipment displays the composition structure of the anti-theft system, ignition system, fuel injection system, instruments, sensors, and actuators; it can demonstrate the working process of ignition and anti-theft systems.
 
Product composition
Emergency stop switch
1PCS
Ignition switch
1PCS
Sensor signal meter
4PCS
Dashboard
1PCS
Ignition coil
1PCS
Fuel injector
4PCS
Fuel injection indicator
4PCS
Anti-theft ECU
1PCS
Engine ECU
1PCS
Throttle valve
1PCS
Air flow meter
1PCS
Canister solenoid valve
1PCS
Oxygen sensor
1PCS
Door sensor
1PCS
Water temperature sensor
1PCS
Intake air temperature sensor
1PCS
Crankshaft position sensor
1PCS
OBD diagnostic seat
1SET
Fault setting module（Manual switch type）
1SET
Mobile stand with test panel
1SET
 
Main features
1. This training board comprehensively displays the structure and composition of the engine anti-theft and ignition system.
2. The test terminals are installed on the test panel. It can measure electrical signals of ignition and anti-theft systems, such as resistance, voltage, current, etc.
3. Fault setting module: manual switch type (optional intelligent type)
 
Training courses
1. Function introduction of the main components of the anti-theft and ignition system;
2. Demonstration of the working process of anti-theft and ignition systems;
3. Electrical signal measurement of sensors and actuators
4. Fault setting and troubleshooting.

Send Message

  • You can only upload 1 attachments at most
  • Supported formats: PDF,JPG,PNG,EXCEL,WORD,STP,IGS,DWG,DXF,PDF,STEP
  • The size of the uploaded file should not exceed 10MB