Automotive fuel injection and ignition system training board

GTAT-4017

Delivery:

EXW

minimum order:

1 set

Supply Ability:

30set / Month

Country of Origin:

Guangzhou,China

Stock Time:

45Day

Technical parameter
1. Dimension: 1380*600*1800mm(LxWxH)
2. Power supply: AC220V, 50Hz

Quantity:

Request a Quote

This educational equipment automotive teaching equipment electronic injector system is designed for describing the working principle of the electronic injectors solenoid valves system. This electronic injector system educational equipment automotive teaching equipment can be used to learn the basic knowledge, and other knowledge and skills of electronic injector system. The automotive teaching equipment is also suitable for the teaching and skills training of related majors in higher vocational colleges and secondary vocational colleges. At the same time, the educational equipment electronic injector system can also be used as an automotive teaching equipment for skill training in technical schools, vocational education centers, and vocational qualification appraisal stations.

Technical parameter

1. Dimension: 1380*800*1800mm(LxWxH)

2. Power supply: AC220V, 50Hz

Product description

This training board adopts the original vehicle fuel injection and ignition system, fully demonstrating the composition and structure of the vehicle fuel injection system and ignition system, and can demonstrate its working process.

Product composition

Ignition system	1SET
Fuel injection system	1SET
Engine ECU	1PCS
Throttle valve	1PCS
Dashboard	1PCS
Ignition switch	1PCS
Fuel tank 10L	1PCS
Fault setting module (Manual switch type)	1SET
Mobile stand with test panel	1SET
Sensor signal meter	1SET
OBD diagnostic seat	1SET

Main features

1. This automotive training board fully displays the composition and structure of automotive fuel injection and ignition system.

2. The test terminals are installed on the test board and can measure electrical signals such as resistance, voltage, current, frequency, etc. of circuit components in the system.

3. Fault setting module: manual switch type (optional intelligent type).

Training courses:

1. Function introduction of the main components of the automotive fuel injection and ignition system;

2. Demonstration of the working process of the engine fuel injection system and ignition system;

3. Electrical signal measurement of sensors and actuators;

4. Use of scanner;

5. Fault setting and troubleshooting

Recommend Products

Send Message